The model dimension can be seen below:
Figure 1: General model
8.5 cm x 8.5 cm base with a 50 cm height models after the Klong. When the water reach a certain height, the inlet is activated. This allows water to flow into the reservoir.
8.5 cm x 8.5 cm base with a 50 cm height models after the Klong. When the water reach a certain height, the inlet is activated. This allows water to flow into the reservoir.
Figure 2: Reservoir model
Water flow in through the inlet at point 1 (15 cm x 50 cm).
The water pressure from the second inlet forces the water to flow into point 2 (25 cm x 50 cm) and ends up at point 3 (10 cm x 50 cm) where it reaches the outlet.
Water flow in through the inlet at point 1 (15 cm x 50 cm).
The water pressure from the second inlet forces the water to flow into point 2 (25 cm x 50 cm) and ends up at point 3 (10 cm x 50 cm) where it reaches the outlet.
The inlet and outlet design model:
The model is based on the actual inlet/outlet which is composed of 5 holes.
The flow of water investigation results is applied into this model.
The model is based on the actual inlet/outlet which is composed of 5 holes.
The flow of water investigation results is applied into this model.
Actual model: